Advertisement
ENGLISH
8
Connecting and disconnecting attachments
Do not insert the mains plug into the wall socket until after you have
connected the attachment.
1
Connect the attachment to the styler by aligning the arrows on
the attachment with the arrows on the styler and pressing the
attachment home ('click') (fig. 2).
2
To remove the attachment from the appliance, press the release
button (1) and pull the attachment in the direction of the arrow
(2) (fig. 3).
Using the appliance
Making curls
We advise you to perform a curl test to determine how long the brush
should be held in your hair to achieve a good result. Start with 8 to 10
seconds.You may have to hold the brush in your hair longer for tighter
curls. Less tight curls will require less than 8 seconds.
1
Snap the retractable bristle brush onto the appliance (see chapter
'Preparing for use').
2
Divide the hair into locks.
3
Take a lock of hair and wind it round the brush. Make sure the
end of the lock is wound in the required direction.
-
Do not wind too much hair round the brush at a time.
-
Do not wind a lock of hair more than twice round the brush.
-
The thinner the lock of hair, the tighter the curl will be.
-
Make sure the lock of hair is in contact with the barrel of the brush.
If you wind the hair at right angles to the scalp, you will give your
hair optimum lift and volume.
4
Switch the appliance on by selecting the preferred setting: (fig. 4).
-
I: gentle airflow for easy styling
-
II: warm airflow for fast styling
Advertisement
