How To Connect The Rgb In Terminals - Panasonic PT-50LC13K Operating Instructions Manual

Installation

How to connect the RGB IN Terminals

Connecting a PC to RGB IN
COMPUTER
RGB OUT
Conversion adapter
(If necessary)
RGB IN Terminal (D-SUB 15P) Pin Layouts
1 1 12 13 14
6 7 8 9 10
1 2 3 4
Connection port view
Notes:
• Some PC models cannot be connected to the set. A conversion adapter is required to use the RGB cable (D-SUB 15P) to
connect a Macintosh computer to the set. There is no need to use an adapter for computers with PC / AT compatible D-SUB
15P terminal.
• The computer shown in the illustration is for example purposes only. Additional equipment and cables shown are not supplied
with this set.
• The picture will become dark if an PC signal with a vertical scanning frequency of 62 Hz is input. To obtain the optimum picture
quality with the projection display, a vertical scanning frequency of 60 Hz is recommended.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed frequency
range.
• Select the desired RGB input position by pressing the PC/MENU or TV/VIDEO button. (P. 35)
• Similar connections are available at the RGB IN 1, 2 Terminals.
18
AUDIO OUT
Connect a cable which matches the audio
output terminal on the computer.
PC audio cable
(M3 stereo mini pin)
RGB cable (D-SUB 15P)
Pin No. Signal name
1 R
15
2 G
3 B
5
4 NC
5 NC
6 Ground for R
7 Ground for G
8 Ground for B
NC: Not connected
Pin No. Signal name
9 NC
10 Ground
11 NC
12 NC
13 HD/CSYNC
14 VD
15 NC