Power On And Off; Initial Setup - Panasonic PT-50LC13K Operating Instructions Manual

Power ON and OFF

Initial Setup

First, check the connection of the Plug to the Wall Outlet and the Antenna/Cable to the RF in Terminal.
(PP. 12-14.)
If using Cable Box, DSS Receiver, or VCR,
• Turn on Cable Box.
• Turn off DSS Receiver, or VCR.
Note:
When the unit is turned on for the fi rst time, Automatic Channel Setting is performed.
22
Press the POWER button to turn the
projection display on.
(Refer to page 23 for "Turning the Power
ON and OFF".)
Automatic Channel Setting is performed.
CH AUTO SET PROCEEDING
Note:
To cancel AUTO SET in progress, press the
SWAP button.
Case 1
When setup is complete, the lowest
channel picture appears.
Case 2
If setup is incomplete, the following
screen appears. Check connection of
Antenna/Cable to the RF in Terminal,
then try Automatic Channel Setting
again. (PP. 26-27)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PRESS ACTION KEY AGAIN