Table of Contents
Advertisement
How to connect the PC Input Terminals
COMPUTER
Installing the ferrite core
1
Pull back the tabs
(in two places)
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz. (However, signals cannot be displayed if signals exceeding 1200
lines will not be displayed properly.)
(2) The display resolution is a maximum 640 × 480 dots when the aspect mode is set to "4:3", and 852 × 480 dots
when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible
to show fine detail with sufficient clarity.
(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible,
you will need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the
specified frequency range.
Signal Names for D-sub 15P Connector
11
12
13
14
15
6
7
8
9
10
1
2
3
4
5
Pin Layout for PC Input
Terminal
Conversion adapter (if necessary)
Audio
Connect a cable which matches
the audio output terminal on the computer.
2
Pin No.
Signal Name
1
R
2
G
3
B
4
GND (Ground)
5
GND (Ground)
POWER
/
INPUT
–
VOL
+
R - STANDBY
G POWER ON
RGB
PC cable
Ferrite core
Less than
(supplied)
7"
(20 cm)
3
Open
Pin No.
Signal Name
6
GND (Ground)
7
GND (Ground)
8
GND (Ground)
9
NC (not connected)
10
GND (Ground)
Connections
PC IN
D-sub 15p
7
/
8
1/8" (3mm) stereo plug
Press the cable
through and close
Pin No.
Signal Name
11
GND (Ground)
12
SDA
13
HD/SYNC
14
VD
15
SCL
AUDIO
13
Advertisement
Table of Contents
