Mitsubishi Electric LDT422V User Manual page 41

OSD screen functions (continued)
CONFIGURATION3
„
POWER SAVE
When you select ON, the power management function
(power save) is activated.
When the RGB1, RGB2, RGB3, or RGB4 input is selected,
the monitor goes into the sleep mode in several seconds
after the sync signal is lost.
When the DVD/HD or VIDEO input is selected, the monitor
goes into the sleep mode in about 10 minutes after the input
signal is lost.
„
HEAT STATUS
The statuses of the cooling fan, brightness, and internal
temperature are displayed.
NOTE : The cooling fan starts running according to the
operating temperature or when COOLING FAN is
ON in the SCREEN SAVER menu.
When the operating temperature substantially
exceeds the operation guaranteed range, the
message "TEMPERATURE WARNING!!" is displayed
on the screen.
„
SCREEN SAVER
You can set the SCREEN SAVER functions to reduce the
risk of "image persistence."
GAMMA:
When you select ON, the gamma mode where image
persistence is diffi cult to occur is used.
COOLING FAN:
When you select ON, the cooling fan always runs.
When you select AUTO, the built-in fan automatically starts
running according to the operating temperature.
BRIGHTNESS:
When you select ON, the brightness decreases.
MOTION:
The screen slightly moves horizontally and vertically
at regular intervals to reduce the effect of the image
persistence.
NOTE : When you select a time period in the MOTION
setting, the monitor enlarges the image and moves
it horizontally and vertically. The portions of the
image out of the display area aren't visible.
To make the entire image visible all the time, arrange
it to fi t within 90% of the screen area at the center.
„
SIDE BORDER COLOR
You can adjust the brightness of the black areas displayed
on both sides of 4:3 images.
„
CONFIGURATION3 RESET
You can reset all the CONFIGURATION3 settings to the
factory defaults.
English-40
Motion
Move
Enlarged
The portion (shaded part) outside the
display area isn't displayed.
90%