Removing Interference / Changing Rf-Output Channel - Panasonic NV-SV121EB Operating Instructions Manual

Removing Interference / Changing RF-output channel

TV screen
The picture with interference
VCR Ch:28
On-Screen Display
Test pattern indication
VCR display
Indication when the RF output
channel is 28 (example)
Indication after changing the RF
output channel to 31 (example)
VCR Ch:31
Test pattern indication
The clear picture
18
In some cases, interference (lines or patterning) or a very poor picture may
appear on the TV when the VCR is connected. If this happens, follow the steps
below to change the video playback channel (RF output channel) to remove the
interference.
MENU
Press the MENU button for more than 5 seconds. The RF output channel
number is displayed on the VCR display.
Press the Numeric buttons or use the Channel (CH) button
TRACKING/V-LOCK
to select a channel number, which differs by 2 or 3 from the
CH
present channel number. (For example, if the original
channel number was 28, enter 31.)
Retune your TV until you receive the Test pattern. It may be necessary to
repeat steps above until you can see the Test pattern clearly. If using a Scart
cable please see the note below.
Press ENTER to finish this setting.
ENTER
Set the RF output channel of the VCR to [- -] (RF OFF) if the VCR is
connected to the TV via the 21-pin Scart cable.
Press MENU for about 5 seconds. The preset channel will be
displayed on the VCR-display.
Press channel select buttons CH or 0 to invoke [- -].
Confirm with ENTER.
...
21 68
(RF OFF)
8 9