Indicators - Mitsubishi Electric WL6700U User Manual

Indicators

This projector has 2 indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problems persist, turn the projector off and consult your
dealer.
Normal condition
POWER S TA TUS
Steady
Off
red
Blinking
Steady
green
green
Steady
Steady
green r
green
Abnormal condition
POWER STATUS
Steady
green
or
Blinking orange
Steady red
Blinking green
Steady red
Steady
Blinking green/red
green
Steady red Blinking red
Steady red
Steady red
Off
Blinking
green/red
Steady
or
Blinking
green/red
Blinking
1
* Duration when LAMP MODE of the INSTALLATION menu is set to LOW. When it is set to STANDARD, this duration will be
shorted.
2
* When LAMP MODE is set to STANDARD, this duration will be shorted up to 2000 hours.
CONDITION
Stand-by
Lamp stand-by for power-on (about 1 minute)
Lamp stand-by for power-off (about 2 minutes)
The power is on. (Normal condition)
CONDITION
Abnormal temperature
• The ventilation grilles are clogged with dust or dirt.
• The room temperature is high.
• The filter is dirty.
The protection circuit is working or the lamp is in an
abnormal condition.
Lamp operation time warning. (Total lamp operation time
reached 3000 hours *1 while the power was on.)
Lamp operation time warning. (Total lamp operation time
reached 3000 hours *1 while the power was off.)
Lamp operation time warning. (Total lamp operation time
reached 4000 hours *1*2 while the power was off.)
The lamp or cover isn't closed.
Abnormal.
STATUS indicator
POWER indicator
EN-38
NOTE
The power cannot be turned off by pressing
the POWER button.
For the first one minute, the power cannot be
turned on by pressing the POWER button.
POSSIBLE SOLUTION
• Clean the ventilation grilles.
• Relocate the projector to a cooler place.
• Clean the filter.
• Wait until the STATUS indicator goes out,
then press the POWER button.
• If the above solution is not effective,
replace the lamp.
Replace the lamp.
Change with a new lamp if this problem
recurs.
Close the cover correctly.
Contact your dealer.