Viewing Computer Images - Mitsubishi Electric WL6700U User Manual

Viewing computer images

A. Connecting the projector to a computer
Preparation:
• Make sure that the power of the projector and that of the computer are turned off.
• When connecting the projector to a desktop computer, disconnect the RGB cable that is connected to the monitor.
COMPUTER/
1
COMPONENT
VIDEO IN 2
R/P G/Y B/P H/HV V
R B
1
COMPUTER/
COMPONENT
VIDEO IN 1
COMPUTER/
1
COMPONENT
VIDEO DVI-D(HDCP)
1
AUDIO IN 1/2
PC audio cable (option)
• Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending
on the type of the computer to be connected.
• Use of a long cable may decrease the quality of projected images.
• Images may not be projected correctly, depending on the type of the connected computer.
• When DVI-D signal is input, some signal setting menus are unavailable.
• Also read the instruction manual of the equipment to be connected.
• Contact your dealer for details of connection.
Computer
2
To monitor port
RGB cable
Computer
To monitor
port (5 BNC)
2
V H/HV B/P G/Y R/P
B R
BNC cable (option)
Computer
2 To DVI
DVI cable (option)
Computer
AUDIO OUT
To audio output
2
terminal
For analog connection:
(For using the COMPUTER/COMPONENT VIDEO IN 2
terminal.)
1. Connect one end of the supplied RGB cable to the
COMPUTER/COMPONENT VIDEO IN 2 terminal of the
projector.
2. Connect the other end of the RGB cable to the monitor
port of the computer.
• When viewing images supplied from an analog-connected
computer, press the COMPUTER 2 button on the remote
control.
For analog connection:
(For using the COMPUTER/COMPONENT VIDEO IN 1
terminal.)
1. Connect one end of a commercially available BNC cable to
the COMPUTER/COMPONENT VIDEO IN 1 terminal of the
projector.
2. Connect the other end of the BNC cable to the 5 BNC
terminals of the monitor port of the computer.
• When viewing images supplied from an analog-connected
computer, press the COMPUTER 1 button on the remote
control.
For digital connection:
1. Connect one end of a commercially available DVI cable
to the COMPUTER/COMPONENT VIDEO DVI-D(HDCP)
terminal of the projector.
2. Connect the other end of the DVI cable to the DVI terminal
of the computer.
• When viewing images supplied from a digital-connected
computer, press the DVI-D(HDCP) button on the remote
control.
• Turn on the main power switch of the projector before
starting the computer.
For audio connection:
1. Connect one end of a commercially available PC audio
cable to the AUDIO IN 1/2 terminal of the projector.
2. Connect the other end of the PC audio cable to the audio
output terminal of the computer.
• This projector uses stereo pin jack for its audio input. Check
the type of the audio output terminal of the connected
computer and prepare a proper cable for connection. Some
computers don't have the audio output terminal.
• Speaker output is mono.
EN-13