Advertisement
Specific Safety Rules
1.
Hold tool by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring. Contact with a "live" wire will
also make exposed metal parts of the tool "live" and shock the operator.
2.
Be aware that this tool is always in an operating condition because
it
does
not have t o be plugged into an electrical outlet.
3.
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
fore operation.
4. Do not cut hollow pipe.
5. Do
not cut oversize workpiece.
6.
Check for the proper clearance beneath the workpiece before cutting so that
7.
Hold the tool firmly.
8.
Check the blade is not contacting the workpiece before the switch is turned
9.
Keep hands away from moving parts.
the blade
will
not strike the floor, workbench, etc.
on.
IO.
When cutting through walls, floors or wherever "live" electrical wires may
be encountered,
DO
NOT TOUCH ANY METAL PARTS
OF
THE TOOL!
Hold the tool only by the plastic handle t o prevent electric shock if you cut
through a "live" wire.
1 1 .
Do not leave the tool running. Operate the tool only when hand-held.
12.
Always switch off and wait for the blade t o come t o a complete stop before
13.
Do not touch the blade or the workpiece immediately after operation; they
removing the blade from the workpiece.
may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
Advertisement
