Panasonic NV-GX7B Operating Instructions Manual page 47

ª Time Code
Time Code signals are data that indicate time measured in
hours, minutes, seconds, and frames (25 frames per
second). If this data is included in a recording, an address is
assigned to each image on the tape.
≥The Time Code is automatically recorded as a part of the
sub-code at each recording.
≥When a new (previously unrecorded) Cassette is inserted,
the Time Code automatically starts from zero. If a recorded
Cassette is inserted, the Time Code picks up from the point
where the last scene was recorded. (In this case, when the
Cassette is inserted, the zero display [0h00m00s00f] may
appear, but the Time Code starts from the previous value.)
≥The Time Code cannot be reset to zero.
≥Unless the Time Code is continuously recorded from the
beginning of a tape, accurate editing may not be possible.
To ensure that the Time Code will be recorded with no
breaks, we recommend the use of the Camera Search
Function ( ) or the Blank Search Function (
-14-
recording a new scene.
ª Memory Stop Function
The Memory Stop Function is useful for the following
operations.
Rewinding or fast-forwarding a tape to a desired
position
1
Set [DISPLAY SETUP] >> [C.DISPLAY] >> [MEMORY].
2
Reset the Tape Counter to zero at the tape position
from which you want to play it back later. (
3
Start playback or recording.
4
After playback or recording has finished:
Rotate the [OFF/ON/MODE] Switch and set the Movie
Camera to VCR Mode.
≥The [VCR] Lamp lights up.
5
Rewind the tape.
≥The tape automatically stops approximately at the
position where the counter was set to zero.
Stopping editing automatically during audio dubbing
1
Set [DISPLAY SETUP] >> [C.DISPLAY] >> [MEMORY].
2
Reset the Tape Counter to zero at the position where
you want to stop editing.
3
Play back the still picture where you want to start
audio dubbing.
4
Start audio dubbing. (
-25-
≥Audio dubbing automatically stops at the position where
the counter was set to zero.
) before
-23-
, )
-6- -11-
)
Others
-47-