Panasonic TX-26LX600P Operating Instructions Manual page 37

Problem
Chaotic image, noisy
No image can be
displayed
Blurry or
distorted image
(no sound or low volume)
Neither image nor
sound is produced
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
An error message appears
"Control with HDMI"
function does not work
The SD card cannot be
used even when it is
formatted
TV goes into
"Standby mode"
An error message
appears
Actions
•
Set "P-NR" in the Picture menu (to remove noise).
(p. 16)
•
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 16)
•
Reset channels. (p. 20)
•
Is the TV in "AV mode"?
•
Is the mains lead plugged into the socket outlet?
•
Is the TV turned On?
•
Check Picture menu (p. 16) and volume.
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 16) in the Sound menu to "Mono".
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 16)
•
If digital sound connection has a problem, select analogue
sound connection. (p. 33)
•
Contact the authorized Service Centre.
•
Switch the TV on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On" again.
(p. 27)
•
Contact the authorized Service Centre.
•
The sleep function is activated.
•
The TV enters "Standby mode" about 30 min. after
broadcasting ends.
•
Follow the message's instructions.
•
If the problem persists, contact the authorized Service Centre.
37