How To Connect The Serial Terminals - Panasonic TH-42PWD3 Operating Instructions Manual

How to connect the SERIAL Terminals

The SERIAL terminal is used when the Wide Plasma Display is controlled by a computer.
COMPUTER
Notes:
(1) Use the RS-232C cable to connect the computer to the Wide Plasma Display.
(2) The computers shown is for example purposes only.
(3) Additional equipment and cables shown are not supplied with this set.
The SERIAL terminal conforms to the RS-232C interface specification, so that the Wide Plasma Display can be
controlled by a computer which is connected to this terminal.
The computer will require software which allows the sending and receiving of control data which satisfies the conditions
given below. Use a computer application such as a programming language to software. Refer to the documentation for
the computer application for details.
Communication parameters
Signal level
Synchronization method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
Basic format for control data
The transmission of control data from the computer starts
with a STX signal, followed by the command, the
parameters, and lastly an ETX signal in that order. If
there are no parameters, then the parameter signal does
not need to be sent.
STX C1 C2 C3 : P1
Colon
Start 3-character
(02h) command (3bytes)
Notes:
(1) If multiple commands are transmitted, be sure to wait
for the response for the first command to come from
this unit before sending the next command.
(2) If an incorrect command is sent by mistake, this unit
will send an "ER401" command back to the computer.
RS-232C cable
D-sub 9p
RS-232C compliant
Asynchronous
9600 bps
None
8 bits
1 bit
None
None
P2 P3 P4 P5 ETX
Parameter(s) End
(1 - 5 bytes) (03h)
SERIAL
RS-232C Conversion cable
D-sub 9-pin female
2
3
5
4
6
7
8
1 • 9
Command
Command Parameter
PON None
POF None
AUU None
AUD None
AMT None
IIS None
VID
YP1
RG1
DAM None
NORM
ZOOM
FULL
JUST
SELF
Connections
5 4 3 2
9 8 7 6
Pin layout for RS-232C
Conversion cable
Details
R X D
T X D
GND
Shorted
Shorted
NC
Control details
Power ON
Power OFF
Volume increase
Volume decrease
Mute (toggle)
Input select (toggle)
AV Mode
Component / RGB mode (processed as a
Y/P /P or RGB signals as set by this unit)
B R
PC mode
Screen mode select (toggle)
NORMAL (4:3)
ZOOM
FULL
JUST
Panasonic AUTO
1
17