1. Manuals
  2. Brands
  3. Miele Manuals
  4. Ventilation Hood
  5. DA 489-4 EXT
  6. Operating and installation instructions

Miele DA 489-4 EXT Operating And Installation Instructions

Hide thumbs Also See for DA 489-4 EXT:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Operation & Installation Manual
Operating and installation instructions
Cooker hood
DA 489-4
DA 489-4 EXT
To avoid the risk of accidents
GiWOZ
or damage to this appliance
it is
to read these
instructions before it is installed
and used for the first time.
M.-Nr. 06 958 270

Advertisement

Table of Contents
loading

Related Manuals for Miele DA 489-4 EXT

Summary of Contents for Miele DA 489-4 EXT

  • Page 1 Operating and installation instructions Cooker hood DA 489-4 DA 489-4 EXT To avoid the risk of accidents GiWOZ or damage to this appliance it is to read these instructions before it is installed and used for the first time. M.-Nr. 06 958 270...

  • Page 2: Table Of Contents

    ......... . 3 .
  • Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
  • Page 4 This appliance complies with all Before connecting the appliance to relevant local and national safety the mains supply, make sure that requirements. Inappropriate use the connection details given on the can, however, lead to personal injury data plate correspond with the on-site and damage to property.
  • Page 5 These models may only be combined the hood, which could cause corrosion. with a Miele external motor. When cooking with oil or fat, chip In countries where there are areas pans and deep fat fryers etc, do not which may be subject to infestation leave the pans unattended.
  • Page 6 All ducting, pipework and fittings appliance only when its operation must be of non-flammable material. These can be obtained from the Miele has been clearly explained to them and they are able to use it safely, Spare Parts department or from builders' merchants.
  • Page 7 In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
  • Page 8 The Miele DSM 400 control module offers the possibility of combining other components with the cooker hood (see "Operation with Control module DSM 400").
  • Page 9 Charcoal filters are available to order socket in the motor unit. through your Dealer or the Miele Spare Parts Department. (See back cover for Having a non-return flap fitted in the contact details and "Technical Data" for ducting ensures that air, once ducted to model number).
  • Page 11 The indicator lamp for the grease filter touch control lights up when the vapour (only for recirculation mode) plates and grease filter need to be cleaned. The touch control is used to reset the operating hours counter every time the grease filter and vapour plates are cleaned (see "Cleaning and care").

  • Page 12: To Switch The Fan On

    If the cooker hood has been connected to a window contact switch via the Miele DSM 400 control ^ Press the run-on option control for module, then the fan cannot be approx. 10 seconds. The first fan switched on if the window is shut.

  • Page 13: Run-On Option

    The indicator lamps for fan power levels I and IV will flash if the automatic It is advisable to run the fan for a few switch-off for the Intensive setting is not minutes after cooking has finished to activated. neutralise any lingering odours in the air, whether you are using air extraction or recirculation mode.

  • Page 14: To Switch The Hob Lighting On

    ^ Press the hob lighting control briefly The hob lighting can be switched on and off independently of the fan. to switch the lighting off. The indicator lamp will go out. Should the cooker hood be left on, the ^ Briefly press the lighting control to fan will switch off automatically after 10 switch on the hob lighting.

  • Page 15: Filter Operating Hours Counter

    The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filter or charcoal filter need to be cleaned or replaced. ^ Press the On/Off control to switch the fan on.
  • Page 16 The grease filter operating hours counter is set at the factory for 30 / indicator lamps show the time hours. This can be lengthened or which has been set: shortened to suit the type of cooking 1st lamp from the left = 20 hours you do.
  • Page 17 ^ Use the / controls to select the desired time. (in recirculation mode) The charcoal filter is needed for recirculation mode. On delivery, the operating hours counter ^ Confirm the selection by pressing the for the charcoal filter is charcoal filter control. For recirculation mode, the operating All the indicator lamps will go out.
  • Page 18 The indicator lamp for the charcoal filter To check the percentage of time set control will light up after the cooker already used: hood has operated for the number of hours set. The charcoal filter must then be replaced with a new one (see "Cleaning and care").

  • Page 19: Housing

    (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a The surfaces and controls are proprietary non-abrasive cleaning susceptible to scratches and agent designed specifically for use on abrasions.

  • Page 20: Vapour Plates And Grease Filter

    The vapour plates and the re-useable metal grease filter remove solid particles from the kitchen vapours (grease, dust, etc) preventing soiling of the cooker hood. The vapour plates and grease filter should be cleaned regularly (at least ^ First, remove the every 3-4 weeks) to avoid a build-up of To do this, pull the vapour fat.
  • Page 21 ^ Clean the filter with a soft nylon brush in a mild solution of hot water and a little washing-up liquid. Do not use "neat" washing up liquid. Do not use: – cleaning agents containing descaling agents, – alkaline cleaning agents (with a pH ^ To remove the side vapour plates, value higher than 7), such as powder hold on the side, pull out of the...
  • Page 22 When removing the filter for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. ^ After replacing the grease filter, press ^ Replace the grease filter. the grease filter control for approx.

  • Page 23: Glass Surfaces

    It is fitted in the canopy above the grease filter. New filters can be purchased from your Miele dealer or from the Miele Spare Parts Department. See back cover for contact details, and "Technical data" for the model number of the filter.
  • Page 24 When fitting for the first time: ^ Activate the operating hours counter (see "Operation"). Always replace the charcoal filter imme- diately if – the indicator lamp for the charcoal filter lights up, – if it is no longer effective in absorbing kitchen odours.

  • Page 25: Changing The Halogen Lamps

    To avoid damaging the lighting or Disconnect the cooker hood from the the hob below, make sure you hold mains supply by: the lamp cover and halogen lamps switching it off at the isolator or securely at all times when handling at the wall socket and removing them.
  • Page 26 1) Extraction 4) and 5): (5 is not required for recirculation mode 2) Recirculation cooker hoods) 3) Ventilation grille positioned at the top The shaded area represents the wall or for recirculation ceiling area for the vent cut-out, for fitting the connection socket and on ...EXT models for feeding the connection cable through to the external motor.

  • Page 27: Safety Distance Between Hob And Cooker Hood (S)

    The safety distance between the top of a cooker or hob and the bottom of the cooker hood glass canopy must measure , unless a greater distance is specified by the manufacturer of your cooking appliance. See "Warning and Safety instructions".
  • Page 29 for use when fitting the tower. for securing the exhaust ducting. for securing the retaining plates and the appliance unit. for exhaust ducting C 125 mm (not The screws and plugs are designed on EXT models). for use in solid walls. For other types of wall construction, for fitting into the exhaust connection alternative fixings will be required.
  • Page 30 Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as Appliance dimensions and the described on the installation sheet. Warning and Safety instructions at A lever is supplied to assist with the the beginning of this book.
  • Page 31 – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...

  • Page 32: Condensate Trap

    If the exhaust ducting is to run through (optional accessory for ...EXT models rooms, ceiling space etc. where there only) may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated.
  • Page 33 If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with national and local For extra safety it is advisable to install safety regulations a residual current device (RCD) with a...

  • Page 34: Connection To A Window Contact Switch

    The Miele DSM 400 control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g. after moving...

  • Page 35: Connection To A Light Switch

    The control module can be used to switch on the cooker hood lighting and also to dim it via a light switch in the house. The tower needs to be removed before the control module can be fitted to the fan unit.
  • Page 36 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer – the Miele Service Department (see back cover for contact details). When contacting the Service Department, please quote the model...
  • Page 37 Extraction system C 125 mm: DA 489-4 EXT ....31.5 kg Level I ....180 m Level II.
  • Page 40 Alteration rights reserved / 3906 M.-Nr. 06 958 270 / 00 gb - GB...

Table of Contents