Advertisement
Quick Links
Operating and installation instructions
Cooker hood
DA 446-4,
DA 447-4,
DA 447-4 EXT,
DA 449-4,
DA 449-4 EXT
To avoid the risk of accidents
GiWOZ
or damage to this appliance
it is
to read these
instructions before it is installed
and used for the first time.
M.-Nr. 06 783 630
Advertisement
Related Manuals for Miele DA 446-4
Summary of Contents for Miele DA 446-4
- Page 1 Operating and installation instructions Cooker hood DA 446-4, DA 447-4, DA 447-4 EXT, DA 449-4, DA 449-4 EXT To avoid the risk of accidents GiWOZ or damage to this appliance it is to read these instructions before it is installed and used for the first time.
- Page 2 ......... . 3 .
- Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
- Page 4 The electrical safety of this This appliance complies with all appliance can only be guaranteed relevant legal safety requirements. when continuity is complete between Inappropriate use can, however, the appliance and an effective earthing lead to personal injury and damage system which complies with local and to property.
- Page 5 These models may only be combined the hood, which could cause corrosion. with a Miele external motor. When cooking with oil or fat, chip In countries where there are areas pans and deep fat fryers etc, do which may be subject to infestation not leave the pans unattended.
- Page 6 All ducting, pipework and fittings they are able to use it safely, must be of non-flammable material. recognising the dangers of misuse. These can be obtained from the Miele Please be aware that on Spare Parts department or from appliances with halogen lighting, builders' merchants.
- Page 7 In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
- Page 8 The Miele DSM 400 control module offers the possibility of combining other components with the cooker hood (see "Operation with Control module DSM 400").
- Page 9 Charcoal filters are available to order the outside, cannot get back into the through your Dealer or the Miele Spare room again. Parts Department. (See back cover for contact details and "Technical Data" for The flap is closed when the cooker model number).
- Page 11 The indicator lamp for the grease filter touch control lights up when the grease (special accessory for recirculation filter and the outer filter need to be mode only) cleaned. The touch control is used to reset the operating hours counter every time the grease filter and the outer filter are each with maximum carrying capacity cleaned (see "Cleaning and care").
- Page 12 If the cooker hood has been connected to a window contact ^ Press the run-on option control for switch via the Miele Control module approx. 10 seconds. The first fan DSM 400, then the fan cannot be setting indicator will light up.
- Page 13 It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction I and IV will flash if the automatic or recirculation mode.
- Page 14 The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to switch on the hob lighting.
- Page 15 To check the percentage of time set The filter operating hours counter is set already used: at 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose 20, 30, 40 or 50 hours –...
- Page 16 (in recirculation mode) The charcoal filter is needed for indicator lamps show the time recirculation mode. which has been set: 1st lamp from the left = 20 hours On delivery, the operating hours counter 2nd lamp from the left = 30 hours for the charcoal filter is 3rd lamp from the left = 40 hours For recirculation mode, the operating...
- Page 17 ^ Use the controls to select the desired time. To check the percentage of time set already used: ^ Confirm the selection by pressing the charcoal filter control. ^ Press the On/Off control to switch the All the indicator lamps will go out. fan on.
- Page 18 300 times. (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-Cloth, or with a proprietary non-abrasive cleaning The surfaces and controls are agent designed specifically for use on susceptible to scratches and stainless steel.
- Page 19 Glass surfaces can be cleaned using a proprietary non-abrasive cleaning Aluminium is affected by the way that light falls on it, by the surrounding agent designed specifically for use on environment and by the angle you glass. observe it from. Avoid oven sprays.
- Page 20 ^ Clean the grease filter and the outer filter with a soft nylon brush in a mild solution of hot water and a little washing-up liquid. Do not use "neat" washing up liquid. Do not use: – cleaning agents containing descaling agents, –...
- Page 21 ^ After cleaning, leave the filters to dry for a while on an absorbent surface before putting them back in place. ^ When removing the filters for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire.
- Page 22 Replacement charcoal filters can be filter. obtained from your dealer or the ^ Take the new filter out of its Miele Spare Parts department. See back cover for contact details, packaging. and "Technical data" for type and reference number.
- Page 23 Always replace the filter immediately if the lamp for the charcoal filter touch control comes on, or if it is no longer effective in absorbing kitchen odours. It should be replaced at least every 6 months. Used charcoal filters can be disposed of with the normal household waste.
- Page 24 ^ Remove the stainless steel outer filter (see "Cleaning and care"). Disconnect the cooker hood from ^ Pull the halogen lamp out of its the mains supply by: socket. Take care not to let the lamp fall onto the hob below. –...
- Page 25 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
- Page 26 DA 446-4 DA 449-4, DA 449-4 EXT 1) Extraction 2) Recirculation 3) Ventilation grille positioned at the top for recirculation 4) The shaded area represents the wall or ceiling area for the vent cut-out, for feeding the connection cable through to an external fan and for fitting the connection socket.
- Page 27 When planning the installation height of your cooker hood, the safety distance between the top of a cooker or hob and the bottom of the cooker hood is as follows, unless a greater distance is specified by the manufacturer of your cooking appliance: 450 mm above electric hobs and cookers.
- Page 29 for use when fitting the tower. for securing the exhaust ducting. for securing the retaining plates. for exhaust ducting C 125 mm (not The screws and plugs are designed on EXT models). for use in solid walls only. For other types of wall construction, for fitting into the exhaust connection alternative fixings will be required.
- Page 30 Before installation, it is important to Should the appliance need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the Installation sheet. "Warning and Safety instructions"...
- Page 31 – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...
- Page 32 If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. (optional accessory) To achieve even further reductions in noise levels, a special silencer can be...
- Page 33 be provided for all poles. All electrical work should be For extra safety it is advisable to install undertaken by a suitably qualified a residual current device (RCD) with a and competent person in strict trip current of 30 mA. accordance with current national and local safety regulations (BS 7671 in the UK).
- Page 34 The Miele DSM 400 Control module can If the control module is disconnected be used to combine the cooker hood in order to operate the cooker hood with other components. without the window contact switch It enables the following: (e.g. after moving house) the cooker hood electronics must be reset by a Miele service technician.
- Page 35 The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. The tower needs to be removed before the control module can be fitted to the fan unit.
- Page 36 Weight DA 446-4 ....22.5 kg DA 447-4....23.2 kg DA 447-4 EXT .
- Page 40 Alteration rights reserved / 1306 M.-Nr. 06 783 630 / 02 en - GB...