Setup Diagrams - M-Audio GSR10 Manual

Setup Diagrams

Connecting a Microphone
(GSR12 and GSR10 Only)
The Figure below shows how a microphone can be connected directly to a GSR12 or GSR10 using an XLR or TRS cable.
Figure 1. Microphone connected to the Mic input (GSR12 shown)
To use a GSR12 or GSR10 with a single microphone:
On the back of the speaker, turn the Level control down (counter-clockwise to Min). Make sure power is Off.
1
Using an XLR or TRS cable, connect a dynamic microphone to the Input on the back of the speaker.
2
Make sure the Mic/Line button is set to the Mic position.
3
Rotate the Mode knob to select Voice mode (you can change this later, but we recommend it for voice and speech). For more
4
information on the tuning presets, see "Modes for Speaker Presets" on page 11.
Turn the speaker on using the Power switch.
5
Speak into the mic while you slowly raise the Level. Don't point the microphone at the front of the speakers to avoid feedback.
6
If desired, press the HPF 75Hz button to engage the high-pass filter. The HPF (high-pass filter) can reduce or eliminate rumble
7
and other low-end noise.
1
2
3
4
Chapter 2: Setups 5