Connections - Panasonic TH-65PHD7E Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
SPEAKER
Terminal (R)
– Cable fixing bands Secure any excess cables with bands as required.
Pass the attached cable
fixing band through the
clip as shown in the
figure.
1
Optional Terminal Board insert Slots (covered)
SLOT1
8
– AC cord fixing
2
1 Connect the AC cord plug to the Plasma Display.
2 Fix the left side clamper.
3 Fix the right side clamper.
Note: The power plug in the illustration may not be the type fitted to your set.
To secure cables connected to Terminals, wrap the cable fixing band around
them then pass the pointed end through the locking block, as shown in the
figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
2
SLOT2
SPEAKER
Terminal (L)
1
3
To tighten:
Pull
SLOT3
From EXTERNAL monitor terminal
on Computer (see page 9)
1
2
2
Close
Push until the hook clicks.
Open
2. Pull off.
1. Keep the knob pressed.
To loosen:
Keep the knob
pressed.
AUDIO
PC IN SERIAL
From SERIAL terminal on
Computer (see page 10)
1
Pull