Reset; Messages On The Unit's Display - Panasonic Diga DMR-PWT420 Operating Instructions Manual

Troubleshooting
Troubleshooting guide
When using Wireless LAN connection, video
from the DLNA Certified media server is not
played back or video frames are dropped
during playback.
• Use 802.11n (2.4 GHz) Wireless router.
Simultaneous use with a microwave, cordless
telephone etc. at 2.4 GHz may result in
connection interruptions or other problems.
• On the "Wireless Settings" screen (
continuous lighting of at least four "Reception"
indicators is the target for a stable connection. If
three or fewer indicators are lit or the connection
is being interrupted, change the position or
angle of your Wireless router. If there is no
improvement, connect to a wired network and
perform the "Easy Network Setting" (
again.

Reset

To return all the settings to the factory preset
Perform "Shipping Condition" or "Default
Settings". ( 70, 83)
92
VQT4E90

Messages on the unit's display

The following messages or service numbers
appear on the unit's display when something
unusual is detected.
SET
("∑" stands for a number.)
80), the
The remote control and main unit are using
different codes. Change the code on the remote
control. (
GUIDE
21) TV Guide data is being downloaded.
HARD ERR
If there is no change after switching the unit to
standby mode and turning it on, consult the
dealer.
NoREAD
• The disc is dirty. (
• The lens cleaner has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to
eject the disc.
PLEASE WAIT
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
PROG FULL
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
87)
9) The unit cannot play.
35)