Advertisement
INSTALLATION
Mounting in the Rack
1. Loosen and remove four screws on the bottom of the camera drive unit, and remove four rubber feet.
2. Place the rack mounting brackets on both sides of the camera drive unit and tighten the supplied screws.
3. Install the camera drive unit with the rack mounting brackets in the rack by using four screws (not supplied.)
Cautions:
• Do not block the ventilation opening or slots on the cover to prevent the appliance temperature from rising.
Always keep the temperature in the rack within 50 °C (122 °F).
• Fix the rear of the appliance on the rack by using an additional mounting bracket (not supplied) if the appliance is
exposed to vibration.
Fix 4 screws.
-3-
Fix 4 screws.
Advertisement
