Table of Contents
Advertisement
Installation
Turn the water off at the supply
before beginning this installation.
Remove the covers from the plaster shields (1).
Trim the plaster shields so that they extend
1/16" outside the surface of the finished wall
().
Seal the wall around the plaster
shields with waterproof sealant.
Failure to seal the wall can lead
to possible water damage.
Use a 17 mm socket wrench to remove the
spout plug.
Use a 7 mm socket wrench to remove the
cartridge housing.
Remove and discard the flush insert.
Lightly grease the cartridge o-ring using the
enclosed lubricant.
Install the cartridge and anti-twist device in the
housing.
2.
1.
17 mm
7 mm
3
Advertisement
Table of Contents
