Table of Contents
Advertisement
Product Specification
Max. Flow Rate
2.2 gpm
Max. incoming water pressure
Recommended water pressure
Max. hot water temperature
Recommended hot water temp
Hole size in mounting surface
18010001
18210001
Max. mounting surface thickness
Model 18010001 has 10 mm supply hoses -- 10 mm - /8" adapters included.
No drain or pull rod is included with model 18010001. Grid drain 06400000 (not included) is
recommended.
Model 18210001 has /8" supply hoses. /8" compression fittings are required (not included).
A pop-up drain is included with 18210001.
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts,
the water heater may be set no higher than 112
Installation
Position the faucet and sealing ring on the mounting
surface.
From beneath the mounting surface, install the fiber
washer, metal washer, and mounting nut. Tighten the
tensioning screws.
18010001 only: Install the adapters on the stops.
Install the filters on the adapters.
145 psi
14.5 - 72 psi
176
F*
o
120
F - 140
F*
o
o
1 1/4"
1 /8"
1 5/8"
F.
o
Advertisement
Table of Contents
