Miele KM 5656 Operating Instructions Manual page 27

What if one or more residual heat indicators flash?
Possible fault
There was a power failure during use.
The burners are turned off.
The residual heat indicators were lit
while the programming mode, e.g.
Safety Lock, Stop and Go, was
selected.
What if when the cooktop is turned off, the burner displays show A, F and
numbers?
Possible fault
The touch controls could not be reset
automatically. They must be reset
manually.
What if the rear burner display shows F, the front burner display shows E
and the timer shows numbers?
Possible fault
Trip the circuit breaker to the cooktop or
disconnect the appliance from the main
power supply for 1 minute.
Frequently asked questions
Fix
Turn the cooktop on as usual.
The residual heat indicators will flash
for about 45 minutes after leaving the
programming mode.
The cooktop can be used as usual.
Fix
See, "Resetting the touch controls -
Manual reset".
If the problem persists, call Miele
Technical Service.
Fix
If the problem persists, call Miele
Technical Service.
27