Miele CVA 610 Operating Instructions Manual page 56

Messages in the display window
The appliance has an electronic safety system that reports any problems in the
display window. Most faults are easily fixed.
Fill coff. beans
Ready for use
Brewunit block.
Brew unit miss.
Descaling
Expel air
Waste unit miss.
Empty wasteunit
Press ENTER
Standby. . .
Press ENTER
Watersystem
fault
Fill water tank
56
The coffee bean container is empty.
The appliance is only dispensing hot
water and steam.
The brew unit is dirty. The appliance is
blocked.
The brew unit is not seated correctly.
The appliance is only dispensing hot
water and steam.
The appliance needs to be descaled.
Air has built up in the system. The
appliance is blocked.
The waste unit is not correctly
positioned or is missing. The
appliance is blocked.
The waste unit is full. Dispensing has
stopped, to prevent coffee grinds from
falling into the appliance.
The appliance is in energy-saving
mode. The lighting is off.
There is water in the base of the
appliance.
The water tank (container) is empty or
missing.
The float switch in the water container
is stuck.
Fill the container with coffee beans.
Clean the brew unit.
Remove the brew unit and reposition it.
Descale the appliance.
– Make sure that the filled water
container is in the appliance.
– Turn the program selector to "On"
with lighting and place a container
under the hot water spout and another
under the steam spout.
– Press the hot water button, turn the
steam selector counterclockwise and
dispense hot water until it flows in
quiet, continuous streams.
– Press the hot water button again.
Turn the steam selector clockwise to
to turn off the water.
Reposition the waste unit correctly.
Empty the waste unit and press ENTER.
Press ENTER.
Call the Miele Technical Service
Department.
Fill the container with cold, fresh
drinking water and place it in the
appliance.
Empty the water container, rinse out,
refill, and place in the appliance.
o ,