Programming - Miele KM 500 Operating And Installation Instructions

Programming

You can change the standard settings
of your hob.
^ With the hob switched off, touch the
hob ON/OFF sensor s and the safety
lock sensor $ or the sensor for the
outer circle of the double
circle/extended zones ? as
required, until P (Programme), S
(Status) and a number appear in the
cooking zone display. This shows the
current setting.
To set the programme:
^ Touch the front left hob sensor.
The relevant number will begin to flash.
^ Touch the + or - sensors to set the
required programme.
Programme
P 0 Demonstration mode and factory
default settings
P 1 Keypad tone when a sensor is
touched
* The factory default settings are shown in bold.
28
To set the status:
^ Touch the front right hob sensor.
The relevant number will begin to flash.
^ Touch the + or - sensor to set the
required status.
To store the new settings in memory,
touch the hob ON/OFF sensor s until
the displays go out.
If you do not wish to store the settings
in memory, touch the safety lock sensor
$ or the sensor for the outer circle of
the double circle/extended cooking
zones ? until the displays go out.
Status* Setting
S 0 Demonstration mode on
S 1 Demonstration mode off
S 9 Factory default settings
reinstated
S 0 Off
S 1 On