Quick Start Guide; Checking The Accessories/Preparing The Remote Control - Panasonic NV-FJ730B Operating Instructions Manual

Quick Start Guide

Checking the Accessories/Preparing the Remote Control

Inserting Remote Control Batteries
1 Open the battery cover and
insert the batteries with the +
and - correctly aligned.
2 Close the battery cover.
Check that you have the accessories shown
Tick off as you unpack
the accessories.
∏ Operating Instructions
VQT9547 (This Book)
∏ Quick Start Guide
VQC4083
∏ Guarantee Card
• Order accessory and consumable items for all Audio Visual Products with ease and confidence either by telephoning our
Customer Care Centre on 08705 357357 Mon-Fri 9:00am-5:30pm
• Or go on line through our Internet Accessory ordering application at www.panasonic.co.uk.
• Most major credit and debit cards accepted.
• All enquires transactions and distribution facilities are provided directly by Panasonic UK Ltd.
• It couldn't be simpler!
1 To Prevent Accidental Erasure of Recording
Break out the tab or the rear side of the tape.
2 To Allow the Tape to be Used Again for Recording
Cover the hole with 2 layers of tape.
If the front panel comes off
1
1 Insert the panel as show in the illustration.
2 Ensure the panel is parallel to the until, then press firmly
down and in on the levers until they click into place.
3 Check that the panel now moves correctly.
• If it does not, remove it and repeat the above procedure.
∏ Remote Control
N2QAKB000024
or
N2QAKB000041
∏ Batteries for the
Remote Control
R6 size
2
Notes for Battery Replacement:
• When the batteries are exhausted, remove them immediately
and dispose of them correctly.
• Do not mix old batteries with new batteries.
• Do not mix different battery types.
• Do not use rechargeable (Ni-Cd) batteries.
• Do not heat or short-circuit the batteries.
• When you do not use the remote control for a long time, take
out the batteries and store them in a cool, dry place.
∏ AC Mains lead
RJA0044-3C
∏ RF lead to connect VCR and TV
K2KF2BA00001,
VJA0728-A
or
K1TWACC00001
Erasure prevention tab
Tape Care
Some do's and dont's on tape care.
DO:
1) Use a good quality branded tape, such as Panasonic.
2) Keep in the box supplied with the tape, or a video case,
when not in use.
3) Try to use the whole tape when making recordings and
avoid re-recording over the same section of the tape
repeatedly as this will help prevent premature tape wear.
4) Take care to insert a tape correctly into the VCR to avoid
damage.
DO NOT:
1) Expose the tape to high humidity or temperature.
2) Expose to liquid.
3) Expose to dust particles by storing directly on a carpet for
example.
4) Use a damaged tape or attempt to repair it.
5) Dismantle the cassette housing.
6) Attempt to lift the front cassette flap or touch the tape
surface.
Adhesive tape
5