Fax – Sending; Fax – Receiving - Panasonic KX-FLB853EX Operating Instructions Manual

9.3.3 Fax – sending
Problem
I cannot send documents.
I cannot send a fax
overseas.
The other party complains
that letters on their
received document are
distorted.
The other party complains
that letters on their
received document are
not clear.
The other party complains
that black lines, white
lines or smudges appear
on their received
document.
9.3.4 Fax – receiving
Problem
I cannot receive
documents automatically.
The display shows
"CONNECTING...", but
faxes are not received.
A blank sheet is ejected.
Cause & Solution
L The telephone line cord is connected to the [EXT] jack on the unit.
Connect to the [LINE] jack (page 23).
L The other party's fax machine is busy or has run out of recording
paper. Try again.
L The other party's machine is not a fax machine. Check with the
other party.
L The other party's fax machine failed to answer the fax
automatically. Send the fax manually (page 32).
L Use the overseas transmission mode (feature #411 on page 66).
L Add two pauses at the end of the telephone number or dial
manually.
L If your line has special telephone services such as call waiting, the
service may have been activated during fax transmission. Connect
the unit to a line that does not have these services.
L Another telephone on the same line is off the hook. Hang up the
extension telephone and try again.
L Try copying the document. If the copied image is clear, there may
be something wrong with the other party's machine.
L The original document is too dark or too light. Change the contrast
setting by pressing {CONTRAST}, then {V} or {^}, and try again.
L The glass or rollers are dirty with correction fluid, etc. Clean them
(page 90, 94). Please do not insert a document before correction
fluid has dried completely.
Cause & Solution
L The telephone line cord is connected to the [EXT] jack on the unit.
Connect to the [LINE] jack (page 23).
L The receiving mode is set to TEL mode. Set to FAX ONLY mode
(page 38) or TEL/FAX mode (page 40).
L The time taken to answer the call is too long. Decrease the number
of rings before the unit answers a call (feature #210 on page 64
and feature #212 on page 66).
L The incoming call is not a fax. Change the receiving mode to TEL
mode (page 39) or TEL/FAX mode (page 40).
L The other party placed the document in their fax machine the
wrong way. Check with the other party.
9. Help
77