Panasonic SC-HTX500 Operating Instructions Manual page 10

Installing and assembling the system
Fixing the casters
Set the caster trays under all 5 casters
to fi x this system.
• At least 2 people are necessary for setting the
caster trays.
Be careful not to catch your fingers.
• See page 7 about how to lift the system.
Glass door assembly
1
Remove 4 screws from the glass holder and take
out the board.
• Use the Phillips-head screwdriver that matches the screw size.
2
Insert the glass door (supplied) to the glass
holder fi rmly and tighten the 2 screws in front
tentatively.
• The illustration at right shows how to fix the left glass door.
• The slippage prevention sheets are
pasted on the glass door insertion
part. Leave the slippage prevention
sheets as they are for installation.
• One side of the magnet catch has
a hole. This is the inner side of the
glass.
3
Close the glass door and adjust the upper and
lower gaps.
Open the glass door carefully so it does not be-
come misaligned. Tighten 2 screws in front fi rmly
and then tighten 2 screws at the back fi rmly.
• Attach the other glass door in the same way.
10
VQT2R75
Cover
Align the cover
with the arrow.
Arrow
Caster tray
(Caster direction)
Make the direction of front caster inward so the
caster tray does not protrude.
outward
(Glass door surface)
Slippage prevention sheets
Left Right
inward
Screw
Board
Phillips-head
screwdriver
Glass
holder
Screw
Magnet
catch
Hole
Left glass
door
(inner side)
Slippage prevention sheet
Adjust the upper and lower gaps.
Screw
Screw
Left glass
door
Phillips-head
(inner side)
screwdriver
Screw
Screw
Screw