Panasonic SX-KC611 Owner's Manual page 35

Part III
1.
In the SONG section, press the REC button .
2.
Use the TRANSPOSE/PROGRAM buttons to select 4:
APC STEP.
SOUND
3.
Press the EXECUTE button.
4.
While playing a chord with your left hand, press the
desired note value key with your right hand to specify
the chord length. Repeat this step to store all the
chords.
When a note value key is pressed, a "beep" tone
indicates that the chord has been stored.
Store a rest by pressing a note value key without
specifying a chord.
The display during chord recording:
Beat number
Measure number
TRANSPOSE TEMPO
REC
L C
R1 R2 CHORD
XBS
APC
7
m
COUNT
RO / ENDING
SYNCHRO
VOLUME
Chord name
The beat number is indicated in increments of . For
example, "B3.5" indicates 3-1/2 beats.
You can press the INTRO [INTR], FILL IN [FIL 1/2] or
ENDING [ENDG] button to store the corresponding
pattern. (An INTRO or COUNT INTRO can be stored
only at the beginning.) When storing a pattern or
searching for a pattern, the abbreviated name is shown
within square brackets [ ].
Note
When the recording procedure is performed, the previously recorded contents and song data loaded from a song
disk as well as BEAT MASTER data are erased.
You cannot record more than 999 measures.
The total recording capacity of all tracks combined is approximately 4500 notes.
When "MEM FULL" appears on the display, no more data can be stored and recording ends automatically.
You cannot begin recording from the middle of a song.
The playback volume can be adjusted. (Refer to page 29.)
Specific tracks can be muted so they are not played back. (Refer to pages 41 and 43.)
If you wish to keep your recorded performance, save it to a floppy disk. (Refer to page 38.)
If you record in the MELODY mode on top of the chord track (C) in which the ending pattern is stored, recording
will automatically end at that point.
To make corrections to the recorded chord progres-
sion, use the
GRAM button to display the chord you wish to modify.
Next, press the DELETE key to erase the stored chord
and then store a new chord. When you use the DE-
LETE key to erase a chord, the recorded contents that
follow are shifted forward by the note value of the
deleted chord.
GENERAL
To go to the end of the chord progression, while
pressing the Reset key (
The CHORD FINDER feature, which shows you how
to finger a specified chord, is available. (Refer to page
30.)
5.
At the end of the chord progression, press the End
key (
The instrument exits the recording mode.
If you wish automatic repeat playback of the chord
progression, press the Repeat key (
the End key (
To store chords using the 1 Finger mode, select this
mode before beginning the recording procedure.
(Refer to page 29.)
GENERAL
CONDUCTOR
TOUCH
R1
SUSTAIN
REVERB
CHORUS
HARMONY
PROGRAM
Recording
and keys or TRANSPOSE/PRO-
), press the
).
) instead of
).
QQTG0588
key.
35