Conductor - Panasonic SX-KC611 Owner's Manual

Part I

Conductor

The CONDUCTOR buttons are used to assign sounds to the keyboard in many different ways. For example, you can
assign two sounds to the entire keyboard so that playing one key will produce two sounds. You can even split the
keyboard into right and left sections (SPLIT), and assign a different sound to each section.
CONDUCTOR settings
R1
R2
R1
R2
R1
L
R2
R1
L
L
R2
The volume of each part can be adjusted independently. (Refer to page 42 .)
When the keyboard is divided into left and right parts, the initialized split point is at C3 (the third C from the bottom,
or left end of the keyboard), but you can change the location of the split point. (Refer to page 44.)
The following conditions are in effect when the AUTO PLAY CHORD is used.
— 1 Finger mode: The LEFT part does not sound.
— 1 Finger, Fingered mode: You cannot assign the RIGHT part sound to the whole keyboard.
— Pianist mode: The keyboard cannot be split.
How sounds are assigned to the keyboard
All keys produce the RIGHT 1 sound.
All keys produce the RIGHT 2 sound.
All keys produce both the RIGHT 1 sound and the RIGHT 2 sound.
RIGHT 1 + RIGHT 2
The left keys produce the LEFT sound and the right keys produce the RIGHT
1 sound and the RIGHT 2 sound.
LEFT
The left keys produce the LEFT sound and the right keys produce the RIGHT
1 sound.
LEFT
The left keys produce the LEFT sound and the right keys produce the RIGHT
2 sound.
LEFT
Sound and effects
RIGHT 1
RIGHT 2
RIGHT 1 + RIGHT 2
RIGHT 1
RIGHT 2
21
QQTG0588