Digital Dubbing - Panasonic NV-DS60B Operating Instructions Manual

Picture-in-Picture Mode
≥If the Movie Camera is turned off, the smaller
picture disappears.
≥The position of a small picture is fixed at the
bottom right of the screen.
ª Playing Back
Repeat Playback
If you continue to press the [1] Button for
5 seconds or longer, the Movie Camera switches
to Repeat Playback Mode, and the [R !]
Indication appears. (To cancel Repeat Playback
Mode, set the [VCR/OFF/CAMERA/M-CARD]
Switch to [OFF].)
Listening to Playback Sound through
Headphones
When you wish to listen to playback sound
through headphones, connect the headphones to
the [PHONES] Socket (l 9) on the Movie
Camera. In this case, no sound (including a
warning sound and shutter sound) will be
reproduced through the built-in speaker of the
Movie Camera.
Multi-Picture Mode
≥The quality of Multi images deteriorates slightly.
≥Playback Multi-Mode screens cannot be output
through the DV Terminal (l 39) or Digital Still
Picture Terminal (l 9).
≥If there is input from DV Terminal, a multi screen
cannot be created.
ª Index Search Functions
≥Index Search may not be possible at the
beginning of tape.
≥Because Photoshot Index Signals are not
recorded on still pictures recorded in Continuous
Photoshot Mode, the Photoshot Index Search
Function cannot be used for these still pictures.
≥Scene Index Search may not function properly if
the interval between 2 scene index signals is
shorter than 1 minute.
ª Playback Digital Effect Functions
≥When [EFFECT1] on the [DIGITAL EFFECT]
Sub-Menu is set to [TRAIL], the digital modes of
[EFFECT2] cannot be used.
≥Signals of images to which digital effects are
added during playback cannot be output from
the DV Terminal (l 9) or Digital Still Picture
Terminal (l 39).
≥Even if Playback Digital Zoom Functions are
being used, images that are output from the DV
Terminal (l 9) or Digital Still Picture Terminal
(l 39) are not enlarged.
≥As you enlarge an image, the quality of image
suffers.
ª Audio Dubbing
≥The blank section of a tape cannot be dubbed.
≥Sounds sent through the DV Terminal cannot be
dubbed.
≥If a tape has a non-recorded portion when the
tape is dubbed, images and sounds may be
disturbed when this portion of the tape is played
back.
≥If you set the tape counter back to 0 at the
position where you want to stop Audio Dubbing
so as to make it possible to use the Memory
Stop Function (l 60), Audio Dubbing is
terminated automatically when the tape reaches
this position.
≥In the case of importing data recorded with
Audio Dubbing to a PC using the PC's software
programme, only the original sound (ST1) may
be imported, depending on the software
programme.
ª Recording the Contents of Other
Equipment
Analog-Digital Conversion
≥When the Movie Camera is connected with other
digital video equipment through its DV Terminal,
images recorded in analog form from other
external equipment can be output to the digital
video equipment through the DV Terminal.
ª Using the DV Cable for Recording

(Digital Dubbing)

≥Regardless of the setting, digital dubbing is
carried out automatically in the same audio
recording mode as that of the Cassette on the
playback-side.
≥The images on the monitor of the recording side
may be disturbed, but it does not affect the
recorded images.
≥Even if Playback Digital Effects or Playback
Digital Zoom Function have been used, these
effects are not output from the DV Terminal.
≥Even if you use device equipped with DV
Terminals (such as IEEE1394), you may not be
able to perform Digital Dubbing in some cases.
≥Do not connect both an S-Video Cable or AV
Cable and a DV Cable.
51