Panasonic TX-26LXD500 Operating Instructions Manual page 7

Quick Start Guide
1
Connect the mains plug to the wall sock et.
Press the [ ] switch on the TV set to turn the set on.
To switch the TV set to Standby mode, press the
on the remote control.
The TV set can be switched on by pressing the
again if it was in Stand by mode.
Note:
This TV will still consume some power even in the Off
mode, as long as the mains plug is still connected to a
live mains socket.
Power Indicator
Standby : Red
On : No Light
DVB Indicator
DVB system active during Timer recording or
standby for Direct TV Recording : Orange (fl ash)
2
Programmes will appear immediately if your dealer has programmed the
TV for you.
If the TV has not been programmed for you then Auto setup will begin.
The TV will search for DVB stations and Analogue stations:
TV stations will be located, sorted into order and stored ready for use.
Stations are sorted into the following order:
• DVB Stations: Are sorted by their logical channel number sent by the
broadcasters, which can be made the favourites list by Profi le Edit. See
page 24.
• Analogue Stations: Are sorted into channel order, but can be changed
to your preference. See page 15.
In this setup, usually Analogue auto setup screen may not be displayed.
The sorted programme order depends upon the TV signal, the broadcasting
system, and reception conditions.
3
TV to VCR or DVD Recorder Download
If a "Q-Link", "NEXTVIEWLINK" or compatible recording device has
been connected to a Scart terminal (AV2 or AV4) before starting Step 1,
programme information will be downloaded to that device.
Only the analogue programme positions will be downloaded to the
recording device, in the same order as stored in the TV. See page 32.
Not all VCRs / DVD Recorders support this download of programme information, some may require to be
started manually.
Refer to the recording device's operating instruction book.
If a recording device other than those described above has been connected, then there will be no download
operation.
Notes:
• If the recording device has not accepted download data from the TV, you may need to select the Download
option from the device's menu system. Refer to the recording device's operating instruction book.
• If Q-Link is not operating correctly, check the following :
The Scart cable is connected to the TV's Scart terminal, AV2 or AV4, and correctly setup in the menu.
The Scart cable is connected to the recording device's compatible (Q-Link, NEXTVIEWLINK or similar
technology) Scart terminal.
The Scart cable is a "fully wired" type.
• For further information on Q-Link and connecting equipment, see page 32, 51, 56.
Timer recording On : Orange
Otherwise : No Light
button
button
Remote control signal sensor
C.A.T.S. sensor
LCD C.A.T.S. (Contrast Automatic Tracking
System) automatically senses the ambient light
conditions and adjusts the brightness and gradation
accordingly, to optimize contrast.
C.A.T.S. is in effect when Viewing mode is set to
Auto. See page 11.
DVB Aute Setup
Please Wait ! 21
Prog. Channel Service Name NetID.
4 30 BBC NEWS 24 12302
5 30 BBCI 12302
6 30 CBBC Channel 12302
7 30 BBC Radio Wales 12302
8 30 BBC Radio Cymru 12302
This will take about 3 mins.
Exit
CH44
AUTO SETUP IN PROGRESS
SEARCHING : PLEASE WAIT
21
Exit
DOWNLOAD IN PROGRESS
PLEASE WAIT
Programme : 63
Remote control unavailable
OK
1 2 3
4 5 6
7 8 9
C 0
IDTV
68
TS ID. Quality
4158 9
4158 9
4158 9
4158 9
4158 9
68
7