How To Connect The Pc Input Terminal - Panasonic TX-26LXD500 Operating Instructions Manual

Connections

How to connect the PC Input terminal

Example:
COMPUTER
Notes:
• Connect a cable which matches the audio output terminal on the computer.
• Computer signals which can be input are those with a horizontal scanning frequency of 31 to 69 kHz and vertical
scanning frequency of 59 to 86 Hz. (However, the image will not be displayed properly if the signals exceed 1,024
lines.)
• When the aspect mode is set to "4:3", maximum of 1,024 x 768 dots area of LCD panel is used for display, and when
the aspect mode is set to "16:9", full area (1,366 x 768 dots) of LCD panel is used for display.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• For applicable PC signals information see page 57.
Signal Names for D-sub 15P Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input
Terminal
Conversion adapter (if necessary)
RGB
(D-sub 15p)
AUDIO
(Stereo plug)
Pin No. Signal Name
R
1
G
2
B
3
NC (not connected)
4
GND (Ground)
5
PC AUDIO IN
L
R
L
AUDIO
R
PC IN
AUDIO IN
Pin No. Signal Name
GND (Ground)
6
GND (Ground)
7
GND (Ground)
8
NC (not connected)
9
GND (Ground)
10
AV
AV1 AV2 AV4
L
R
AUDIO
RGB VIDEO RGB
VIDEO S-VIDEO VIDEO
S-VIDEO
Pin No. Signal Name
NC (not connected)
11
NC (not connected)
12
HD/SYNC
13
VD
14
NC (not connected)
15
COMPONENT
Y
P
B
P
R
VIDEO
53