Quick Installation Guide - Veilux VPIP-D118-/O User Manual

4 . 2 . Q u i c k I n s t a
4 . 2 . Q u i c k I n s t a
1. Connect PC and Veilux VPIP-D1XXX-O / VPIP-D1XXX-I to Network Device(HUB)
I. Prepare a PC which needs to be connected to Network.
II. Connect PC (or Lab-Top) with Product as Fig 4-1.
Power will be applied to product separately via Power Device (AC Adaptor).
2. IP Camera Network Configuration using IP Installer
Run the CD and Install IP Installer included in CD. Once install IP Installer, "WinPcap" will be installed. If
not install "WinPCap", IP Installer won't operate.
.
For the Network Configuration of product, IP Installer should be higher than 3.0.1 Version.
For the Window 7 User,"WinPCap" should be higher than 4.0 Version.
1. Run IP Installer > Select Network Adaptor > Click OK.
2. If Configuration Window open, Click ① > Double Click the relevant product at ② > Fill in ④ >
Configure ⑤ > Fill in ⑥ or ⑧.
3. If Configuration is completed, Click Set Button ⑨ to apply Configuration.
4. Access to Camera Admin Page by clicking ⑩.
Website: www.Veilux.net
Veilux User Manual for VPIP-D118-/O, D126X-I/O, D127X-I/O, D133X-I/O,
D136X-I/O, D136X With WDR-I/O, D137X-I/O
I= Indoor D= Outdoor
l l a t i o n G u i d e
l l a t i o n G u i d e
Fig 4-1. LAN Cable Connection Diagram
Phone# 1-800-510-6528
Rev.1.0 (April 2011)
32