Veilux VPIP-D118-/O User Manual page 20

-
 Alarm In/Out (ALARM/AUX)
Used for connecting alarm sensor, alarm annunciation device to Veilux VPIP-D1XXX-O / VPIP-D1XXX-I.
Alarm IN GND
Aux OUT(GND)
 Aux
Relay output is provided for connecting alarm devices or for remote on/off control of devices such as light.
Relay is normal open and it will be closed upon alarm annunciation or remote on. The relay is capable
of switching 30V AC/DC,
additional relay switch as shown as below figure.
Fig 2-5. Relay Connection Diagram(Left : lower than 30V, 2A, Right : Higher than 30V 2A)
 Alarm
Connect external alarm sensor. Examples of sensing devices are infrared sensor, motion sensor,
heat/smoke sensor, magnetic sensor, etc. Connect the two wires of the sensors to "SNS In". The sensor
type (NC/NO) can be set in admin page. 10mA can be flown into sensor device. Multiple sensor devices
can be connected in parallel.
Website: www.Veilux.net
Veilux User Manual for VPIP-D118-/O, D126X-I/O, D127X-I/O, D133X-I/O,
D136X-I/O, D136X With WDR-I/O, D137X-I/O
I= Indoor D= Outdoor
Class
Alarm IN
Aux OUT
2A. For the application which needs power switching beyond this limit, use
Phone# 1-800-510-6528
Description
Sensor In (+). NC/NO Selectable in Admin Mode
Ground for Sensor In
Alarm Output Terminal
Ground for Sensor Output
Rev.1.0 (April 2011)
20