Bar Code Travel Direction; Bar Code Travel Speed Considerations; Sv Scanner/Verifier Setup Procedure - Hand Held Products SV Series User Manual

Bar Code Travel Direction

Bar codes can be scanned in a static location, or more commonly with on-line
scanner/verifiers, they can be scanned while moving through the laser beam.
The illustration below shows the two directions a bar code can travel through the
laser beam. They are designated "picket fence" and "ladder" directions.
Picket Fence Travel
Laser Beam
Direction
Ladder Travel Direction
The SV unit must be programmed for the direction of travel of the codes being
analyzed. If the codes are being scanned in a static condition, use the picket
fence travel direction.

Bar Code Travel Speed Considerations

A bar code should be present in the beam for at least five scans for the most
reliable operation. The SV Series performs a minimum of 100 scans/analyses
per second. At that rate, each analysis is accomplished in 10 milliseconds
maximum. Therefore, a bar code must be in the beam for at least 50
milliseconds to be reliably analyzed. Some SV models have higher minimum
scans/analysis; therefore a bar code must be in the beam for less amount of time
for those models.

SV Scanner/Verifier Setup Procedure

Installation of an SV scanner/verifier requires proper mounting position, output
port configuration(s), and LED configurations to ensure the reliable and accurate
operation. This section describes the procedures for using ScanView to ensure
proper SV setup and installation.
Each SV unit has a label showing the specified mounting distance and angle for
its particular scanner. Follow the steps below to ensure the SV unit is properly
mounted and programmed.
Quick Check® SV Series User's Guide 5 - 3