Preparing For Hot Lamination - Lervia LAMINATOR KH 4410 Operating Instructions Manual

KH4410_Laminator_UK

8. Preparing for hot lamination

➩
Insert the pouch guide
holes on the back side of the
laminator.
➩
Insert the power plug of the lamina-
tor into a power socket.
➩
Be sure to find a stabile location for
the appliance.
➩
Switch on the appliance by flipping
the ON / OFF switch
ON / OFF LED indicator light
on.
➩
Set the selector switch for the pouch
thickness and cold lamination
the desired pouch thickness
(80 or 125 micron). The laminator
now heats up to the operating
temperature.
• As soon as the green LED indicator
light "Ready"
laminator has reached its operating
temperature.
As soon as the operating tempera-
ture is reached, the green LED indi-
cator light "Ready"
up. For a more even laminating re-
sult, we recommend that you only
begin the laminating process after
waiting for an additional approx.
2-3 minutes, particularly when using
thinner pouches (less than 125 micron),
or when adjusting a different pouch
thickness.
➩
Lay the document to be laminated
into a laminating pouch of the ap-
propriate size.
09.06.2006 9:23 Uhr
into the
. The red
turns
to
lights up, the
will light
Seite 7
Make certain that all corners of the
document have at least two milli-
metres of space to the edge of the
laminating pouch as shown in Fig. 1.
Make certain that you only use a
single pouch for laminating. Open it
up first, as shown in Fig. 2.
Fig. 1
For information about the lamina-
tion process, please read section 10.
Fig. 2
- 7 -
Lervia KH 4410