Storage; Disposal; Warranty & Service; Importer - Lervia LAMINATOR KH 4410 Operating Instructions Manual

KH4410_Laminator_UK
Lervia KH 4410
Cleaning the inside of the appliance:
With every lamination, contaminants are
deposited on the rollers inside the lamina-
tor. Over time, this reduces the perfor-
mance of the laminator. You should
therefore clean the rollers inside the
laminator after use.
➩
Prepare the appliance as described
in section 8 "Hot lamination" until
the green LED indicator light
"Ready"
➩
Then run a sheet of DIN A4 paper
folded in the middle (maximum
thickness 1.0 mm) ...
• without a laminating pouch and
• with the fold first
... slowly into the slot for manual pouch
input .
➩
Let go of the sheet as soon as you
notice that it is being pulled in auto-
matically.
• The contaminants on the rollers inside
the laminator are now transferred
to the sheet of paper. The paper is
output from the pouch ejector slot
of the laminator.
➩
Repeat the cleaning several times.
Each time, use a new, clean sheet of
paper.
If you no longer see any contaminants
on the paper, the rollers inside the
laminator are clean.
09.06.2006 9:23 Uhr
lights up.
Seite 10

13. Storage

Let the appliance cool off completely
before storing it.
Do not store the laminator in damp
locations as moisture could enter
inside the appliance. (E.g. cellars)!

14. Disposal

Do not dispose of the device in
normal domestic waste.
Dispose of the device over a registered
waste disposal firm or through your
communal waste disposal facility.
Observe the currently valid regulations.
In case of doubt, consult your waste di-
sposal facility.
15. Warranty & service
The warranty conditions and the service
address can be found on the warranty slip.

16. Importer

Kompernaß GmbH
Burgstrasse 21
D-44867 Bochum
www.kompernass.com
- 10 -