Installing A Memory Module - Lenovo ThinkServer TD200 Installation And User Manual

To install a hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the filler panel from one of the empty hot-swap bays.
3. Make sure that the drive handle is open; then, slide the hard disk drive into the
4. Push the drive handle in until it latches.
Notes:
1. When you turn on the server, check the hard disk drive status LEDs to verify
2. If the server is configured for RAID operation using an optional ServeRAID
If you have other optional devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 76.

Installing a memory module

The following notes describe the types of dual inline memory modules (DIMMs) that
your server supports and other information that you must consider when you install
DIMMs.
4
Drive handle
on page 36.
hot-swap bay.
that the hard disk drive is operating correctly.
If the amber hard disk drive status LED is lit continuously, that drive is faulty
and must be replaced. If the green hard disk drive activity LED is flashing, the
drive is being accessed.
adapter, you might have to reconfigure your disk arrays after you install hard
disk drives. See the ServeRAID
for additional information about RAID operation.
Chapter 5. Installing optional devices and replacing customer replaceable units
™
documentation on the ServeRAID Support CD
63