Installing A Voltage Regulator Module; Installing An Adapter - Lenovo ThinkServer TD200 Installation And User Manual

Installing a voltage regulator module

Installing an adapter

|
|
56
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Installation and User Guide
To install a voltage regulator module, complete the following steps:
1. Locate the VRM connector on the system board, next to the heat sink for
microprocessor 2 (see "System-board internal connectors" on page 25).
2. Open the retaining clips on each end of the VRM connector.
3. Turn the VRM so that the keys align with the connector.
4. Insert the VRM into the connector by aligning the edges of the VRM with the
slots at the end of the VRM connector. Firmly press the VRM straight down into
the connector by applying pressure on both ends of the VRM simultaneously.
The retaining clips snap into the locked position when the VRM is seated in the
connector.
5. Install the air baffle (see "Installing the air baffle" on page 51).
6. Return the power-supply cage to its closed position (see "Closing the
power-supply cage" on page 44).
7. Install the hot-swap power supply or power supplies (see "Installing redundant
power supply and fans" on page 74).
8. Install and lock the left-side cover (see "Installing the left-side cover" on page
77).
9. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
v Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this section. If you must change the
switch or jumper settings on the adapter, follow the instructions that come with
the adapter.
v Avoid touching the components and gold-edge connectors on the adapter.
v PCI slots 1 and 6 support half-length PCI adapters only.
v PCI slots 2, 3, 4, and 5 support full-length and half-length PCI adapters.
v The PCI Express extender card supports a full-length adapter.
v The PCI-X extender card supports two full-length adapters.
v PCI slots 1 and 5 support the RAID adapters.
v PCI slot 2 supports a VGA adapter.
v The PCI configuration:
– Slot 1 is a PCI Express x8 slot with x8 links, PCI Express Base Specification
Revision 2.0 compliant.
– Slot 2 is a PCI Express x16 slot with x8 links, PCI Express Base Specification
Revision 2.0 compliant.
– Slots 3 and 4 are PCI Express x8 slots with x4 links, PCI Express Base
Specification Revision 2.0 compliant.
– Slot 5 is a PCI Express x8 slot with x8 links, PCI Express Base Specification
Revision 2.0 compliant.
– Slot 6 is a PCI 33/32 slot, PCI 2.2 compliant.
– PCI Express extender card slot 7 is a PCI Express x8 slot with x4 links, PCI
Express 1.0a compliant.