B) Removing The Device; C) If It Fails To Work - Kompernass TRONIC KH 3002 Operating Instructions Manual

IB_KH3002_E2497_UK_V1.qxd
• are on the same side, positive on the
connectors is at the top (inside) and
negative at the bottom (outside).
• are on opposite sides, positive on the
connectors is at the bottom (outside)
and negative at the top (inside).
-
Once you have connected your device to
the energy station with the appropriate
connectors ...
• you can set the main switch to "ON" –
your device will now be supplied with
power.
• A green LED "Full" is illuminated as
soon as the main switch is switched
on and sufficient energy is available.
• A red LED "Empty" is illuminated as
soon as the main switch is switched
on – but the battery is almost empty.
Caution!
You must first recharge the battery if the
red LED "Empty" is illuminated.
Otherwise the battery will be depleted,
usually resulting in a considerable loss of
charging capacity.
Hint: Once you have established the cor-
rect connector assignment for your device,
you can secure the connector with insula-
ting tape to the receptacle so that you
will immediately have a "suitable" cable
for your device available the next time.
17.01.2007 9:17 Uhr
+ +
-
Seite 7

b) Removing the device

To discontinue supplying your device
with power from the energy station,
first ...
• switch off the device...
• and set the main switch on the energy
station to "OFF" (centre position).
In this way you prevent that current is
still flowing while the connector is being
pulled. Sensitive devices sometimes mal-
function as a consequence.
• Now you can pull the adapter cable
connectors from both the device and
the energy station.

c) If it fails to work...?

If none of the two LEDs light up after
switching on, the 10 A fuse on the ener-
gy station might have blown. Changing
the fuses is described in more detail in
Chapter " Fuses ".
Should an LED light up on the energy
station after switching on but your devi-
ce fail to work:
• you should immediately switch off the
energy station.
• In this case, initially check whether
the cable is correctly connected – and
"Positive" and "Negative" have not
been switched. If required, also check
the fuse in your device as described in
its instructions.
- 7 -
KH 3002