Tripod Data Systems SURVEY PRO User Manual page 92

Survey Pro GPS User's Manual
1. Create a new job.
• Enter Point Name 2 as the starting point and enter a starting
location of (5000, 5000, 100).
2. Set the base and rover.
• Go to Start GPS Survey, choose Start Survey with One Point
Setup>.
•
Choose Set New Base and 'connect' to the Demo Mode
receiver. A simulated autonomous base position is received,
and you can Set the base.
• Connect to the Demo Mode rover, Set the Rover.
•
You are now ready to collect data in your new coordinate
system.
3. Data collect points 3,4,54, and CHAP.
4. Move the base receiver to a different setup.
• Go to Start GPS Survey, choose Set New Base.
• Pick point 54, tap Next > and Set to set the base. Tap Set to
set the rover.
• You are now ready to collect data from this setup.
5. Check a point to verify setup and solution.
• Tap Control to open the Control Points screen. Occupy points
CHAP and 3 as Check points. The results should be perfect.
Existing Job: Ground – TDS Localization
Scenario
You have already done a job at an existing site. The original job was
completed with a closed traverse starting from of an assumed
bearing, so there is no projection and no datum to define the local
coordinate system. You want to measure new points on this site with
your RTK GPS equipment, and calculate coordinates in the original
local system.
92