Tripod Data Systems SURVEY PRO User Manual page 23

•
An existing point with geodetic coordinates, the GPS base
receiver is set with this coordinate, and the base reference
position is configured in Survey Pro.
• An existing point with plane only (N,E,Elev) coordinates when
the coordinate system is solved, the plane coordinate is
transformed into geodetic, the GPS base receiver is set with this
coordinate, and the base reference position is configured in
Survey Pro.
• A new point, or, an existing plane point when no projection is
solved, you start from an autonomous position. You will GET an
autonomous position from the GPS receiver for your first base
setup. You then SET this reference position in the GPS receiver
and configure the base position in Survey Pro.
Note: It is strongly recommended that you use only one autonomous
GPS base position in a job. If you must use multiple autonomous
setups in a single job, you will be prompted to setup and select a
separate site record for each setup group.
4. Tap Next>.
The final step of the Base Setup wizard will depend on the base point
chosen. If the base (lat, lng, ht) is known or can be computed, the
final step is to SET the base at the known geodetic position. If the
base (lat, lng, ht) is not known, the final step is to GET an
autonomous position to SET the base with.
RTK Data Collection
23