Tripod Data Systems SURVEY PRO User Manual page 9

Receiver Settings
1. Go to the Job | Settings | Receiver and tap Receiver Settings to
open the Receiver Setup screen. Alternatively, you can tap
Create Receiver or Receiver Settings when prompted to connect to
a receiver during Start GPS Survey (Page 22).
2. Enter a Name for this receiver profile, choose the Brand and
Model, and select the communication settings.
3. Tap Rx Settings to connect to the receiver and set the receiver
profile's properties.
4. Choose a Receiver Mode for this profile. This will be one of: RTK
Base, RTK Rover, or Post Processing.
5. If this profile is for an RTK receiver, set data link settings on the
Rx Settings – Data Modem card. Also, if your receiver has special
settings, choose the desired parameters on the General card.
6. Tap OK to close the Rx Settings screen, and OK again to create or
update the receiver profile.
This receiver profile is now ready to use in a GPS survey. You should
now set the RTK and/or post processing settings on the following
cards of the Job | Settings screen
Survey Methods
Receiver Setup
9