Data Collection - Tripod Data Systems SURVEY PRO User Manual

Survey Pro GPS User's Manual
5. Set the Acceptance Criteria.
Acceptance Criteria is used to check each solution you
accept. If the measurement exceeds the criteria, you will
be prompted to accept or reject the point. Check this box
if you want to enable criteria checking. Enter a maximum
value for HRMS, VRMS, and/or PDOP in the fields. Only
fields with a non-zero value will be used for criteria
checking.
To accept data points automatically using the selected
criteria, check the Auto Accept box at the bottom of this
page.
6. Tap OK to return to the Data Collection screen.

Data Collection

The GPS Data Collection screen is used to add points to
the job file. There are several methods to collect data.
Occupy Point
Use this method if you want to occupy a point with the
rover for any amount of time. When you start a point
occupation, the receiver will be put in static mode for the
most precise measurement possible, and the event will
be recorded in the post processing log file (depending on
your settings).
1. Go to the Survey | Data Collection screen.
2. Enter a point name in the Point field.
Note: If you have Store GPS Raw Data set to + Rx Raw
(or + OBN for Ashtech users), your point name must be a valid Site Id
for the receiver model. If your point name is not valid, you will be
prompted to change it.
3. Enter a Description.
52