Playing Back From The Usb Mass Storage Class Device - JVC UX-EP25 Instructions Manual

When disconnecting the iPod, make sure that the
System is turned off.
To remove the
connector from your
iPod, squeeze the
buttons on the sides
and pull.
To playback sounds on the iPod
To start:
To select a track
Decrease the track numbers
Increase the track numbers
Search... Press and hold 4 or ¢.
OFF ... Press and hold 6.
Playing Back from the USB mass stor-
age class device
This System is equipped with a USB MEMORY
terminal on the front panel. You can connect a
USB mass storage class device such as a USB
fl ash memory device, Digital Audio Player (DAP),
etc. to this System.This System cannot recognize
a USB mass storage class device whose rating
exceeds 5V/500mA.
• Remember you cannot send any data to your
USB mass storage class device from this
System.
13
To pause:
✎
IMPORTANT
• Always set volume to "VOLUME MIN" when
connecting or disconnecting the other equipment.
• Connect the USB mass stotrage class device
directly to the system. Using a USB hub may result
in malfunction.
• Coded or encrypted tracks in a special method
cannot be played on the unit.
• The USB mass storage device's battery is charged
while the System is turned on.
To connect the USB mass storage class device
When connecting a USB mass storage class
device, refer also to its manual.
DAP
• When disconnecting the USB mass storage
class device, make sure that the System is in
the stop condition.
To playback sounds on the
USB mass storage class device
✎
IMPORTANT
• An iPod does not play on the USB MEMORY
terminal. "RESTRICT" appears on the display when
an iPod is connected to the USB MEMORY terminal
while USB MEMORY is selected for the source.
To start:
• The USB MEMORY lamp on the left of the
USB MEMORY terminal fl ashes while USB
MEMORY is selected for the source.
or
To stop: