Speaker Connecilons; Speaker.terminals; Speakers 2; Soeakers 1 - JVC RX-206BK Instructions Manual

r
I
i
Speaker Connections
;WW
You can connect two pairs of speakers (four speakers total) to
this receiver. The two pairs of speakers are called Speakers 1
and Speakers 2.
Important! Be sure to match the polarity of the speaker term|
nals with the polarity of the terminals on the receiver. (+) to
(+) and (-) to (-).
Note: This receiver is only for use with speakers having im-
pedance of 8 to 16 ohms. Check your speaker specifications
to make sure the speakers have the correct impedance.
Speaker fermlnals
O Wnen connecting speakers, open each terminal and insert the
end of the speaker wire as shown.
€) Ctose the terminals as shown to clamp the speaker wires in
prace.
Speakers I
Connect the first pair of speakers (Speakers 1) to the receiver
as follows:
@ Connect the (+) and (-) terminals of the right-side Speaker 1
to the top (+) and (-) terminals marked RIGHT on the
receiver.
@ Connect the (+) and (-) terminals of the left-side Speaker 1
to the top (+) and (-) terminals marked LEFT on the
receiver.
Speakets 2
lf a second pair of speakers (Speakers 2) is to be used,
connect them to the receiver as follows.
@Connect the (+) and (-) terminals of the right-side Speaker 2
to the bottom (+) and (-) terminals marked RIGHT on the
ranoirror
@ Connect the (+) and (-) terminals of the left-side Speaker 2
to the bottom (+) and (-) terminals marked LEFT on the
receiver.
@
o
Soeakers 1
left
right
- -
- I E
- - r r - -
I I E I I E
t - . - - - r
r n , - - : n r
r l ! - - [ r r
L U - - . - r
E - . - - . -
-
E H
t//-U z/zGfl
fTrrn\t tTFrtYt
I I | | [ f , t r I . t E l t a
vv
oo
Speakers 2
left right
B
o
o
0
AC Powet Connectlons
tmpot|anil Before you plug the power cord into an outlet,
make sure all stereo components are connected correctly.
Do not connect stereo components requiring more than 180
watts (total) to the receiver.
Gautlon. lo prevent electrlc.hoclq
tum dl rtcrso com-
ponont! otf bclore you Instlll or nemove power cordl.
Plug the power cord on the back of the receiver into a 120
volt. 60 Hz AC household electrical outlet.
You can connect the power cords of the other stereo compo-
nents to the two AC outlets on the back of the receiver.
Note: < RX-207TN/RX-2068K >
The AC outlets provide power'whenever the receiver is
plugged in, regardless of the r*eiver's power switch
setting.
< RX.3O7TN/RX-3O6BK>
The AC outlets are connected to the receiver's
ON/STANDBY circuits. When the power switch is set fo
STANDBY, power will not be supplied.
Page 6