Front Panel Controls - JVC RX-206BK Instructions Manual

< RX-2O7TV/
RX.2O6BK>
-
-ffi-
< RX.3O7TN/
RX-3O6BK>
l-J
,,iffi.
Front Panel Controls
O Power Swltch
Press this switch to turn on oower to the receiver. Press the
switch again to turn off the power and activate the STANDBY
mooe.
Note: The receiver uses a small amount of power (5 watts) in
the STANDBY mode. To disconnect power completely, unplug
the power cord.
@Speaker
Swltch
Press the two SPEAKERS switches in to turn Soeakers 1 and
Speakers 2 on. Press the SPEAKERS switches out to turn the
speakers off.
@Headphone.tack
Stereo headphones may be connected here. For private
listening, press both speaker switches off.
@ Source $elect
Use these six buttons to choose the stereo source you want
to listen to. Source Indicator Lights show which source(s) have
been selected.
PllONOt Press to listen to records.
CD; Press to listen to CDs.
FIG Press to listen to FM broadcasts.
Itl Press to listen to AM broadcasts.
1APE 1., Press to use the tape deck connected
to the TAPE 1 jacks on the receiver.
TAPE 2NTDEO SOUNDT Press to use the tape deck, graphic
equalizer, or video equipment con-
nected to the TAPE 2llIDEO SOUND
jacks on the receiver.
G) 9ource lndlcator Hghts
These live lights tell you which stereo source(s) are being
played through the receiver. The TAPE 2 MONITOR indicaior
may turn on or off independently while other indicators are
@ Surround Indlcator Llghts
This indicator lights up when the surround sWitch is ON.
O Tuner DIspIay Wlndow
The Tuner Display Window indicators provide information on
AM and FM broadcast reception. The Tuner Display Window
is also used to set and recall oreset radio stations.
Page 8
O <RX-2o7TN/RX-2o6BK>
BECE YED Indlcator
This indicator lights up when signals are received from the
remote control unit.
< RX.3O7TN/RX.3O6BK>
BECEMD and POWER 9IANDBY lndlcator
This indicator lights up when signals are received from the
remote control unit or when the receiver is in the STANDBY
mode.
9Remote
Sensor
The Remote Sensor receives the signal sent by the remote
control unit.
Note: lt is important to keep the Remote Sensor clear of
obstructions in order for it to receive signals from the remote
control unit.
@Bass Control
This controls the low-frequency sound range. Turn the BASS
control right to boost bass response. Turn left to decrease
' bass.
@ trcble Control
This controls the high-frequency sound range. Turn the
TREBLE control right to boost treble response. Turn left to
decrease treble.
@?alance
Control
This controls the volume balance between the left and right
speakers. Turn the BALANCE control right to increase volume
for the right speaker(s). Turn the BALANCE control left to
increase volume for the left speake(s). ln the center position,
left and right speakers have equal volume.
@Volume
Control and Yolume lndlcator Hght
Turn the VOLUME control to adjust the volume. The VOLUME
indicator lights up when the power is ON and fickers when
the remote control is used for VOLUME and FADE MUTING.
@funer
Use the buttons on the tuner to tune in the AM or FM broad-
cast station you want to listen to. These buttons are also used
for setting and recalling preset radio stations.
@9unound
Swltch
This switch turns the surround sound effect ON or OFF.
< RX-2O7TN/
RX.2O6BK>
I
-<RX3O7TN/
RX.3O6BK>
M E
I