Initial settings
When the TV is first turned on, it enters the initial setting
mode, and the JVC logo is displayed. Follow the
instructions on the on-screen display to make the initial
settings.
1 Make sure you set the VCR/TV/DVD switch to
the TV position.
• You cannot turn the TV on when the VCR/TV/DVD
switch is set to the VCR or DVD position.
2 Press the #
#
# button on the remote control
#
The receiver power lamp changes from red to green.
After a short interval the TV power lamp lights green
and the JVC logo is displayed.
• Check that the AC plugs on the power cords from the
TV and receiver are connected to AC outlets.
TV (front)
Receiver (front)
10
VCR/TV/DVD
Switch
Yellow button
Blue button
Remote control
sensor
Power lamp
A button
Power lamp
• If the power lamp stays red and does not change to
green:
Your TV is in the standby mode. Press the #
(Standby) button again to turn your TV on.
• If the JVC logo does not appear this is because your
TV has already been turned on for the first time:
use the "LANGUAGE" and "AUTO PROGRAM"
functions to make the initial settings. For details, see
"INSTALL" on page 31.
3 Press the a
a
a button
a
The LANGUAGE menu appears.
LANGUAGE
BACK
TV
OK
D0002(E)-EN
4 Press the 5
5 and 6
6 buttons to choose
5
5
6
6
ENGLISH. Then press the a
The on-screen display will then be in English.
The COUNTRY menu appears as a sub-menu of the
AUTO PROGRAM function.
There are two COUNTRY menus. Pressing the yellow
button changes the COUNTRY menu as follows:
BACK
BACK
START
TV
OK
TV
OK
MORE
D0003-EN
5 Press the 5
5
5 and 6
5
6
6 buttons to choose the
6
country where you are
• For uses in the UK:
To receive SKY 1 you need a satellite tuner. You
must have the satellite tuner set to SKY 1 before
starting the AUTO PROGRAM function which
follows.
6 Press the blue button to start the AUTO
PROGRAM function
The AUTO PROGRAM menu appears and received TV
channels are automatically stored in the programme
numbers (PR).
• To cancel the AUTO PROGRAM function:
Press the b button.
AUTO PROGRAM
EDIT
PR
CH 10
AV
01
02
20%
03
04
05
BACK
06
TV
OK
07
08
09
BACK
TV
OK
MOVE
D0004-EN
After the TV channels have been registered in
the programme numbers (PR), the EDIT menu
appears
• If you want to, you can now edit the programme
numbers (PR) using the EDIT/MANUAL function.
For details, see "EDIT/MANUAL" on page 32.
• If you do not want to edit programme numbers (PR),
go to the next step.
a button
a
a
START
MORE
ID
CH / CC
BBC1
CH
21
CH
22
CH
23
CH
24
CH
25
CH
26
CC
01
CC
02
CC
03
ID
INSERT
DELETE
MANUAL