C. Orifice Conversion - Maytag CHG9800BAB Installation Instructions Manual

C. ORIFICE CONVERSION
1. FROM NATURAL GAS TO LP GAS:
a. Place burner wrench (part no. 8002P026-60,
available from your dealer or authorized service
agency*) over surface burner assembly with ig-
niter positioned inside gap in wrench ring (figure
13A). This prevents ignitor from being crushed
when wrench tightens on burner assembly. Ro-
tate burner assembly approximately one-
eighth turn counter-clockwise and lift from main
top (figure 13B). Using a 1/2" deep-well socket,
tighten each burner orifice hood approximately
two complete turns clockwise TO THE
CLOSED POSITION. Replace burner assem-
bly in main top and rotate approximately one-
eighth turn clockwise using burner wrench until
burner locks into position with ignitor facing
rearward.
ORFICE HOOD
FIGURE 13B
b.
On ranges, use the 1/2" open end wrench to
tighten the oven orifice hood (1-figure 18) ap-
proximately two complete turns clockwise TO
THE CLOSED POSITION. See figure 14B.
C.
Adjust burner air shutter to the widest opening
that will not cause the flame to lift or blow off the
burner when cold.
NOTE: Correctly adjusted sealed burners will
blow off without a pot over the burner. These
should be adjusted with a pot in place.
INSIDE
WRENCH GAP
__ CLOCKWISE
TO TIGHTEN
_
ZN-HDUSIE _ _ - RI_4OVAL
FIGURE 13A
*If burner wrench is not available locally, contact
Maycor Parts and Service, 240 Edward Street,
Cleveland, TN 37311. (615-472-3500).
,
FROM LP GAS TO NATURAL GAS:
a. Place burner wrench (part no. 8002P026-60,
available from your dealer or authorized service
agency*) over surface burner assembly with ig-
nitor positioned inside gap in wrench ring (figure
13A). This prevents ignitor from being crushed
when wrench tightens on burner assembly. Ro-
tate burner assembly approximately one-
eighth turn counter-dock'wise and Iift from main
top (figure 13B). Using a 1/2"deep-well socket,
loosen each burner orifice hood approximately
two complete turns counter-clockwise. Re-
place burner assembly in main top and rotate
approximately one-eighth turn clockwise using
burner wrench until burner locks into position
with ignitor facing rearward.
b°
On ranges, use the 1/2" open end wrench to
loosen the oven orifice hood (1-figure 18) ap-
proximately two complete turns counter-clock-
wise until the flames on the burner do not in-
crease in length. See figure 14A.
c. Adjust burner air shutter to the widest opening
that will not cause the flame to lift or blow off the
burner when cold.
NOTE: Correctly adjusted sealed burners will
btow off without a pot over the burner. These
should be adjusted with a pot in place.
ORIFICE
HOOD
FIGURE 14A
NATURAL GAS
SETTING
ORIFICE
HOOD
FIGURE 14B
LP GAS
SETTING
-9-