Connecting The Range; Electrical Supply Connection; Gas Supply Connection - Maytag CHG9800BAB Installation Instructions Manual

t
FIGURE 3
b.
The house piping and/or range connector used to
connect the range to the main gas supply must be
CLEAN, free of metal shavings, rust, dirt and liq-
uids (oil or water). Dirt, etc. in the supply lines can
work its way into the range manifold and in turn
cause failure of the gas valves or controls and
clog burners and/or pilot orifices.
NOTE: THE MAIN TOP DOES NOT LIFT UP.
c. Turn off all pilots and main gas valve of other gas
appliances.
d. Turn off main gas valve at meter.
F.
CONNECTING THE RANGE
1. ELECTRICAL SUPPLY CONNECTION:
The range requires 120 votts, 60 cycle alternating
current from an outlet capable of supplying 15 am-
peres.
!rom t.isp ug.
e,
f,
g.
h.
Before connecting range, apply pipe thread com-
pound approved for LPG to all threads.
Connect range to gas supply at regulator using
rigid pipe or adaptors supplied with flexible con-
nector. See rating plate for type of gas range has
been manufactured for. Gas conversion kits are
available.
Turn on main gas valve at meter, and relight pilots
at other gas appliances.
Apply soap suds to the gas connection at range
and check for leakage. Check for leakage at all
gas connections and fittings in the range.
CAUTION: NEVER CHECK FOR LEAKS WITH
A FLAME.
i. Connect etectric supply cord to wall receptacle
120 volt, 60 cycle alternating current, at 15 am-
peres.
2. GAS SUPPLY CONNECTION:
A TRAINED SERVICEMAN MUST MAKE THE GAS
INSTALLATION.
a,
AGAS CUTOFF VALVE SHOULD BE PUT IN AN
ACCESSIBLE LOCATION IN THE SUPPLY
LINE AHEAD OF THE RANGE, FOR TURNLNG
ON AND TURNING OFF GAS SUPPLY. If range
is to be connected to house piping with flexible or
semi-rigid metal connectors for gas appliances,
CONNECTOR NUTS MUST NOT BE CON-
NECTED DIRECTLY TO PiPE THREADS. THE
CONNECTOR MUST BE INSTALLED WITH
ADAPTORS PROVIDED WITH THE CONNEC-
TOR.
Adjust burner air shutter to the widest opening
that wilt not cause the flame to lift or blow off the
burner when cold.
NOTE: Correctly adjusted sealed burners will
blow off without a pot over the burner. These
could be adjusted with a pot in place.
AOAPTOR
FIGURE 4
Regulator & Connection
OFF
-4-