Electronic Control Setup; Maintenance Instructions - Whirlpool MDG22PRBWW0 Installation Instructions Manual

1. Use a small flat-blade screwdriver to remove plug strip from
the dryer door opening. Slide the head of the screwdriver
under the strip, being sure not to scratch the dryer surface.
Lift up.
2. Remove the strike using a #2 Phillips screw driver.
3. Install strike on the opposite side.
A,
A. Plug strip (cannot be
seen from this angle)
B. Door catch
1.
Reattach door to dryer front panel with the 4 screws.
@
A. Dryer front panel
B. Door assembly
f--..
2. Check for fingerprints on the inside of the glass.
Clean glass if necessary.
3. Close door and check that it latches securely.
ELECTRONIC CONTROL SETUP
See Tech Sheet for information on setup.
MAINTENANCE INSTRUCTIONS
Maintenance instructions:
m Clean lint screen after each cycle.
m Removing accumulated lint:
* From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualified person.
From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
m Keep area around dryer clear and free from combustible
materials, gasoline and other flammable vapors and liquids.
m Keep dryer area clear and free from items that would obstruct
the flow of combustion and ventilation air.
If dryer does not operate, check the following:
[] Electric supply is connected.
[] Circuit breaker is not tripped or house fuse is not blown.
[] Door is closed.
[] Controls are set in a running or "ON" position.
[] START button has been pushed firmly.
[] For gas dryers, check that gas supply shutoff valves are set
in open position.
If you need assistance:
The Commercial Laundry Support Center will answer any
questions about operating or maintaining your dryer not covered
in the Installation Instructions. The Commercial Laundry Support
Center is open 24 hours a day, 7 days a week. Just dial
1-800 NO BELTS (1-800-662-3587) -- the call is toll free.
When you call, you will need the dryer model number and serial
number. Both numbers can be found on the serial-rating plate
located in the dryer door well.
22